The GNU General Public License (GPL) version 2.0 or the GNU
#COMMAND PROMPT COMMANDS MAC ADDRESS SOFTWARE#
Certain components of this software are licensed under Owned by other third parties and used and distributed under The copyrights to certain works contained in this software are To display the output which has several contents of MAC Address List, below is another example of the command execution done by performing remote access via SSH service to a real Cisco router network device ssh Access VerificationĬisco xxxxx xxxxx xxxxxxxxxx (XXXX-XXXX) SoftwareĬopyright (c) 2002-2012, Cisco Systems, Inc. The image below shows how the device is actually located which is a single device without any connection elsewhere : Since the above device is not even connected to any other devices, it doesn’t record any MAC Address of any devices at all, show the table of MAC Address List displayed is empty.
This is the sample of the executed output shown in the image : After enabling privilege command mode has already done successfully, type the ‘show mac address-table’ command in it as shown below : To enable a privilege command mode in a router, read the following article title ‘Enabling Cisco Network Device to Permit Privilege Command’ in this link. So, in order to display that information about the MAC address entries which is displayed in the form of a table, use the show mac address-table command and type it in the command prompt provided in the CLI (Command Line Interface) within the privilege command mode.
0 kommentar(er)
